The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the body ECU removal/installation are shown below.
1.INSPECT EDU RELAY (EDU)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the EDU relay.
2.INSPECT IG2 RELAY (IG2)
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
If the result is not as specified, replace the IG2 relay.
82730
3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
- | - |
Before performing the relay inspections for the relays of the instrument panel junction block assembly, inspect the EFI-MAIN NO. 1, EFI-MAIN NO. 2 and EFI NO. 1 fuses.
Remove the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL
Remove the body ECU from the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL
Inspect the EFI-MAIN NO. 1 relay.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2B-1 - 2G-5 | Battery voltage not applied to terminals 2P-8 and 2K-3 | 10 kΩ or higher |
| Battery voltage applied to terminals 2P-8 and 2K-3 | Below 1 Ω |
If the result is not as specified, replace the instrument panel junction block assembly.
Inspect the EFI-MAIN NO. 2 relay.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2B-1 - 2G-3 | Battery voltage not applied to terminals 2P-9 and 2J-5 | 10 kΩ or higher |
| Battery voltage applied to terminals 2P-9 and 2J-5 | Below 1 Ω |
If the result is not as specified, replace the instrument panel junction block assembly.
Install the body ECU to the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>INSTALLATION
Install the instrument panel junction block assembly.
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>INSTALLATION