Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
| *1 | Centering Bolt |
| *2 | Standard Bolt |
Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts for standard bolts when making adjustments.
A bolt without a torque specification is shown in the standard bolt chart.
Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS
67004
1.INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH
Check that the clearance measurements of areas A to F are within the standard ranges.
| Area | Measurement | Area | Measurement |
|---|---|---|---|
| A | 3.2 to 6.2 mm (0.126 to 0.244 in.) | B | 3.2 to 6.2 mm (0.126 to 0.244 in.) |
| C | 2.8 to 5.8 mm (0.110 to 0.228 in.) | D | -1.5 to 1.5 mm (-0.059 to 0.059 in.) |
| E | 4.2 to 7.2 mm (0.165 to 0.283 in.) | F | 4.2 to 7.2 mm (0.165 to 0.283 in.) |
67004
2.ADJUST REAR DOOR PANEL SUB-ASSEMBLY LH
Using SST, loosen the hinge bolts on the body and adjust the door position.
Tighten the hinge bolts on the body after the adjustment.
Loosen the hinge bolts on the door and adjust the door position.
Tighten the hinge bolts on the door after the adjustment.
Using a T40 "TORX" socket wrench, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.