Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR MAIN SWITCH
RM3270E _59 Vehicle Exterior _041717 DOOR / HATCH _0205108 POWER BACK DOOR MAIN SWITCH G

DOOR / HATCH  POWER BACK DOOR MAIN SWITCH  INSPECTION  


PROCEDURE

Hide 84965 1.INSPECT POWER BACK DOOR MAIN SWITCH

a.

Check the resistance.

i.
B338152C02
1.271,3.01 1.552,2.698 true 2.26,3.01 2,2.698 true 1.625,1.594 1.938,1.75 0.313,0.156 10 false *a 1.094,3.021 1.521,3.219 0.427,0.198 10 false MSW 2.281,3.021 2.75,3.219 0.469,0.198 10 false MSE
*a Component without harness connected
(Power Back Door Main Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
9 (MSW) - 6 (MSE) Switch off 10 kΩ or higher
Switch on Below 1 Ω


If the result is not as specified, replace the power back door main switch.



b.
B338153C02
1.469,3.021 1.677,2.677 true 2.042,3.01 1.844,2.698 true 1.635,1.563 1.948,1.719 0.313,0.156 10 false *a 1.344,3.031 1.958,3.229 0.615,0.198 10 false ILL+ 2.104,3.01 2.719,3.208 0.615,0.198 10 false ILL-
*a Component without harness connected
(Power Back Door Main Switch)


Inspect the illumination operation.

i.

Apply battery voltage to the power back door main switch connector, and check that the power back door main switch LED illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 8 (ILL+)
Battery negative (-) → Terminal 7 (ILL-)
LED illuminates


If the result is not as specified, replace the power back door main switch.