84930
1.INSPECT DOOR CONTROL SWITCH ASSEMBLY
Check the resistance.
| *a | Component without harness connected
(Door Control Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 1 (E) - 4 (CSW) | Back door control switch assembly not pushed | 10 kΩ or higher |
| 1 (E) - 4 (CSW) | Back door control switch assembly pushed | Below 1 Ω |
If the result is not as specified, replace the door control switch assembly.
| *a | Component without harness connected
(Door Control Switch Assembly) |
Inspect the illumination operation.
Apply battery voltage to the door control switch assembly connector, and check that the door control switch assembly LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 3 (ILL+)
Battery negative (-) → 2 (ILL-) |
LED illuminates |
If the result is not as specified, replace the door control switch assembly.