Home › Engine / Hybrid System › 1GD-FTV FUEL › FUEL INJECTOR › 2015.08–2016.01
RM3270E _51 Engine / Hybrid System _041673 1GD-FTV FUEL _0205208 FUEL INJECTOR G

1GD-FTV FUEL  FUEL INJECTOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 23670 1.CHECK INJECTOR ASSEMBLY

a.

Start the engine and drive the vehicle until the engine coolant temperature reaches 60°C (140°F) or higher.


b.

Allow the engine to idle for 1 minute or more.


c.

Connect the GTS to the DLC3.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine / Data List / Injection Volume and Injector Feedback Val. #1 to #4.

Powertrain > Engine > Data List
Tester Display
Injection Feedback Val #1
Injection Feedback Val #2
Injection Feedback Val #3
Injection Feedback Val #4
50003 234 778,779,780,781

f.

Read the values when the engine is idling.


g.

Check that the "Injector Feedback Val. #1 to #4" values are within the specification.

Standard:
Tester Display Engine Condition Specified Condition
Injection Volume Idling 3 to 10 mm3/st
Injector Feedback Val. #1
Injector Feedback Val. #2
Injector Feedback Val. #3
Injector Feedback Val. #4
Idling -3.0 to 3.0 mm3/st


If the result is not as specified, replace the fuel injector assembly.


Hide 2.CHECK INJECTOR COMPENSATION CODE

HINT:

If the injector compensation code is not correctly registered, it may cause malfunctions.


a.

b.

Check that the compensation code of the installed injector assembly is the same as the code registered in the ECM. If the code is not the same, register the injector compensation code on the injector assembly.

Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>REGISTRATION