Home › Brake › BRAKE (FRONT) › FRONT BRAKE
RM3270E _54 Brake _041693 BRAKE (FRONT) _0205360 FRONT BRAKE G

BRAKE (FRONT)  FRONT BRAKE  INSPECTION  


PROCEDURE

Hide 1.CHECK BRAKE CYLINDER AND PISTON

a.

Check the cylinder bore and piston for rust and scoring.

If necessary, replace the disc brake cylinder assembly and front disc brake piston.


Hide 2.CHECK PAD LINING THICKNESS

C321915

a.

Using a ruler, measure the pad lining thickness.

Standard thickness:

11.5 mm (0.453 in.)


Minimum thickness:

1.0 mm (0.0394 in.)


If the pad lining thickness is less than the minimum, replace the front disc brake pad.


Hide 3.CHECK DISC THICKNESS

C321916

a.

Using a micrometer, measure the disc thickness.

Standard Thickness:

28.0 mm (1.102 in.)


Minimum Thickness:

25.0 mm (0.984 in.)


If the disc thickness is less than the minimum, replace the front disc.


Hide 4.CHECK DISC RUNOUT

a.
C321917

Check the front axle hub bearing looseness (Click here Drivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>ON-VEHICLE INSPECTION) and front axle hub runout (Click here Drivetrain>AXLE AND DIFFERENTIAL>FRONT AXLE HUB>ON-VEHICLE INSPECTION).


b.

Install the front disc with the 6 hub nuts.

Torque:
105 N*m (1071 kgf*cm, 77 ft.*lbf)


c.

Using a dial indicator, measure the disc runout 10.0 mm (0.394 in.) from the outer edge of the disc.

Maximum disc runout:

0.05 mm (0.00197 in.)


NOTICE:

Do not place the magnetic portion of the dial indicator near the axle hub or speed sensor.


If the runout is more than the maximum, change the installation position of the disc so that runout is the smallest possible. If the runout is more than the maximum even when the installation position is changed, grind the disc. If the disc thickness is less than the minimum, replace the disc.


d.

Remove the 6 hub nuts and front disc.