Use the same procedure for the RH and LH sides.
The procedures listed below is for the LH side.
47341B
1.INSTALL FRONT NO. 1 WHEEL CYLINDER TUBE LH
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, install the front No. 1 wheel cylinder tube LH to the disc brake cylinder assembly LH.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Do not bend or damage the front No. 1 wheel cylinder tube LH.
Do not allow any foreign matter such as dirt and dust to enter the front No. 1 wheel cylinder tube LH from the connecting points.
47313A
2.INSTALL FRONT FLEXIBLE HOSE
Attach 2 new clips to the front flexible hose.
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the flexible hose to the brake line and front No. 1 wheel cylinder tube LH while holding the front flexible hose with a wrench.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
Do not bend or damage the brake line and front No. 1 wheel cylinder tube LH.
Do not allow any foreign matter such as dirt and dust to enter the brake line and front No. 1 wheel cylinder tube LH from the connecting points.
3.BLEED BRAKE LINE
4.BLEED CLUTCH LINE (for Manual Transmission)
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
5.INSTALL FRONT WHEEL