Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.DRAIN BRAKE FLUID
Wash off brake fluid immediately if it comes in contact with any painted surface.
47319F
3.REMOVE REAR FLEXIBLE HOSE LH
Remove the union bolt and gasket from the rear disc brake cylinder assembly LH.
Use a container to catch brake fluid as it drains out.
Disconnect the brake tube from the rear flexible hose LH with a union nut wrench while holding the rear flexible hose LH with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
Remove the clip and rear flexible hose LH.
47321B
4.REMOVE REAR BRAKE TUBE FLEXIBLE HOSE
Using a union nut wrench, disconnect the brake tube from the rear brake tube flexible hose while holding the rear brake tube flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
Remove the 2 clips.
Remove the rear brake tube flexible hose.
Using a union nut wrench, disconnect the brake tube from the rear brake tube flexible hose while holding the rear brake tube flexible hose with a wrench.
Do not bend or damage the brake tube.
Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.
Remove the 2 clips.
Remove the rear brake tube flexible hose.
47356
5.REMOVE NO. 6 FLEXIBLE HOSE BRACKET
Remove the bolt and No. 6 flexible hose bracket from the rear axle housing.
47355A
6.REMOVE NO. 5 FLEXIBLE HOSE BRACKET
Remove the bolt and No. 5 flexible hose bracket.