Home › General › INTRODUCTION › REPAIR INSTRUCTION › 2015.08–2016.01
RM3270E _V1 General _041669 INTRODUCTION _0207265 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL


Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed Link
w/ Power Back Door System:

Reset back door close position


Power back door system (Click here)

NOTICE:

After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect or Inoperative Function when Necessary Procedure is not Performed Link
ECM
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


(Click here)
for RC61F:

Performing iMT installation information reset


·

iMT system

·

DTCs are output


(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.
Injector assembly
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting (Click here)
Engine assembly
·

Injector compensation code registration

·

Pilot quantity learning


Engine starting (Click here)

Clear Crank Time Compensation Data


Engine starting (Click here)
Crankshaft angle sensor plate

Clear Crank Time Compensation Data


Crank time compensation data compensation amount is same as before replacement, affecting crank time compensation data (Click here)
Air fuel ratio sensor Clear A/F Sensor Compensation data - (Click here)
Exhaust manifold converter sub-assembly Clear DPF Thermal Deterioration Data - (Click here)
·

Diesel throttle body assembly

·

Electric EGR control valve assembly

·

Turbocharger sub-assembly

·

Turbocharger nozzle vane control actuator


Perform initialization - (Click here)
AC60F:
·

Automatic transmission assembly

·

Transmission valve body assembly

·

Any of the shift solenoid valves


Reset memory
·

Large shift shock

·

Engine overruns


(Click here)
AC60F:

Automatic transmission fluid


ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly
Skid control ECU (Brake actuator assembly) Yaw rate and acceleration sensor zero point calibration and store system information
·

DTCs are output

·

ABS warning light illumination

·

Slip indicator light illumination

·

VSC disable or malfunctioning


(Click here)
Yaw rate and acceleration sensor (airbag sensor assembly)
·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


Air conditioning amplifier assembly Servo motor initialization DTCs are output (Click here)
·

No. 1 air conditioning radiator damper servo sub-assembly

·

No. 1 blower damper servo sub-assembly


Servo motor initialization DTCs are output (Click here)
w/ Smart Entry and Start System:
·

Certification ECU (smart key ECU assembly)

·

Steering lock ECU (steering lock actuator assembly)

·

Electrical key transmitter sub-assembly


Code registration
·

Wireless door lock control system

·

Smart entry and start system

·

Immobiliser system

·

Steering lock system


Refer to the Service Bulletin for the registration procedure.
w/o Smart Entry and Start System:
·

Key

·

Transponder key ECU assembly


Code registration Engine starting Refer to the Service Bulletin for the registration procedure.
w/o Smart Entry and Start System:
·

Door control transmitter assembly

·

Door control receiver


Recognition code registration Wireless door lock control system (Click here)
·

Power window regulator motor assembly

·

Door window regulator assembly

·

Door glass

·

Door glass run


Initialize power window control system
·

Jam protection function

·

Power window control system

·

Auto up and down function

·

Remote control function

·

Key-off operation function

·

Catch protection function


(Click here)
Multiplex network door ECU Reset Back Door Close Position Power back door system (Click here)
Body ECU Initialize automatic light control system Automatic light control system (Click here)
·

Headlight leveling ECU assembly

·

Rear height control sensor sub-assembly LH

·

The vehicle height changes due to replacement of suspension components or after performing such operations as removal and reinstallation


Headlight leveling ECU assembly initialization Headlight leveling function (Click here)
Front wheel alignment adjustment
·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


VSC malfunctioning (Click here)