Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM3270E _54 Brake _041691 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0213502 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1440  Steering Angle Sensor Unusual Bank Angle Detected  


DESCRIPTION

If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.

This is not a malfunction if the system and sensor circuits are normal and normal VSC operation resumes.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1440 Steering Angle Sensor Unusual Bank Angle Detected Driving at a steep bank angle Yaw rate and acceleration sensor (Airbag sensor assembly)

PROCEDURE

1.CHECK DTC

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105
b.

Turn the ignition switch off.


c.

Start the engine.


d.

Perform a road test.



Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Proceed to
DTC C1440 is output
DTC C1440 is not output
Yaw rate and acceleration sensor DTC is output



DTC C1440 is output

2.CLEAR DTC

DTC C1440 is not output

END

Yaw rate and acceleration sensor DTC is output

2.CLEAR DTC

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105
HINT:
·

If the skid control ECU (brake actuator assembly) determines that the vehicle is being driven at a steep bank angle, the skid control ECU (brake actuator assembly) stores DTC C1440 while VSC operation is temporarily disabled.

·

It is not a malfunction if the system and sensor circuits are normal and if the normal VSC operation resumes, which automatically clears DTC C1440, after the vehicle is returned to a normal position.



Result:
Proceed to
NEXT



NEXT

END