Make sure that fingers or articles of clothing do not get caught in moving parts when performing this test.
85110
1.INSPECT WINDSHIELD WIPER MOTOR ASSEMBLY
| *a | Component without harness connected (Windshield Wiper Motor Assembly) |
Check the LO operation.
Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (+1)
Battery negative (-) → Terminal 4 (E) |
Motor operates at low speed |
If the result is not as specified, replace the windshield wiper motor assembly.
Check the HI operation.
Apply battery voltage to the windshield wiper motor connector and check the speed of the windshield wiper motor assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (+2)
Battery negative (-) → Terminal 4 (E) |
Motor operates at high speed |
If the result is not as specified, replace the windshield wiper motor assembly.