Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY
RM3270E _52 Drivetrain _041685 DRIVE SHAFT / PROPELLER SHAFT _0217828 FRONT DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C237734

Check that there is no excessive play in the radial direction of the inboard joint and outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check that the inboard joint boot and outboard joint boot are not cracked or damaged, and no grease is leaking out.


e.
C237735N06
1.5,1.396 1.771,1.604 0.271,0.208 10 false (A)

Check that the inboard joint boot and outboard joint boot are not stretched or contracted when the front drive shaft assembly is at the standard length.

Length (A):
Item Length
for LH Side 555.9 mm (1.82 ft.)
for RH Side


NOTICE:

Keep the front drive shaft assembly level during inspection.


If the inboard joint boot and outboard joint boot are stretched or contracted, correct them.