17111
1.INSPECT INTAKE MANIFOLD
Using a precision straightedge and feeler gauge, measure the warpage of the surface of the intake manifold that contacts the cylinder head sub-assembly.
0.4 mm (0.0157 in.)
If the warpage is more than the maximum, replace the intake manifold.
17141
2.INSPECT EXHAUST MANIFOLD
Using a precision straightedge and feeler gauge, measure the warpage of the surface of the exhaust manifold that contacts the cylinder head sub-assembly.
0.4 mm (0.0157 in.)
If the warpage is more than the maximum, replace the exhaust manifold.
13511
3.INSPECT CAMSHAFT
Inspect the circle runout.
Place the camshaft on V-blocks.
Using a dial indicator, measure the circle runout at the center journal.
0.1 mm (0.00394 in.)
If the circle runout is more than the maximum, replace the camshaft.
Using a micrometer, measure the cam lobe height.
| Cam Lobe | Specified Condition |
|---|---|
| Intake | 54.89 to 54.91 mm (2.1610 to 2.1618 in.) |
| Exhaust | 54.99 to 55.01 mm (2.1650 to 2.1657 in.) |
| cam Lobe | Specified Condition |
|---|---|
| Intake | 54.39 mm (2.141 in.) |
| Exhaust | 54.49 mm (2.145 in.) |
If the cam lobe height is less than the minimum, replace the camshaft.
4.INSPECT CAMSHAFT OIL CLEARANCE
Clean the camshaft bearing caps and journals.
Check the camshaft bearings for flaking and scoring.
If the bearings are damaged, replace the camshaft bearing caps and cylinder head sub-assembly as a set.
Install the bearings to the camshaft bearing caps and cylinder head sub-assembly.
Place the camshaft on the cylinder head sub-assembly.
| *a | Plastigage |
Lay a strip of Plastigage across each of the journals.
Install the camshaft bearing caps.
Do not turn the camshaft.
Remove the camshaft bearing caps.
| *a | Plastigage |
Measure the Plastigage at its widest point.
0.022 to 0.074 mm (0.000866 to 0.00291 in.)
0.1 mm (0.00394 in.)
If the oil clearance is more than the maximum, replace the camshaft bearings. If necessary, replace the camshaft and cylinder head sub-assembly.
Completely remove the Plastigage.
Remove the camshaft.
5.INSPECT CAMSHAFT THRUST CLEARANCE
Install the camshaft.
Using a dial indicator, measure the thrust clearance while moving the camshaft back and forth.
0.08 to 0.28 mm (0.00315 to 0.0110 in.)
0.35 mm (0.0138 in.)
If the thrust clearance is more than the maximum, replace the camshaft bearings. If necessary, replace the camshaft and cylinder head sub-assembly.
Remove the camshaft.
11101A
6.INSPECT CYLINDER HEAD SET BOLT
| *a | Measurement Area |
Using a vernier caliper, measure the diameter of the most elongated threads in the measurement area.
11.76 to 11.97 mm (0.463 to 0.471 in.)
11.6 mm (0.457 in.)
If a visual check reveals no excessively thin areas, check the center of the cylinder head set bolt (see illustration) and find the area that has the smallest diameter.
If the diameter is less than the minimum, replace the cylinder head set bolt.