Home › Engine / Hybrid System › 5L-E ENGINE MECHANICAL › TIMING BELT › from 2016.01
RM3270E _51 Engine / Hybrid System _048650 5L-E ENGINE MECHANICAL _0231144 TIMING BELT G

5L-E ENGINE MECHANICAL  TIMING BELT  INSPECTION  


PROCEDURE

Hide 13568 1.INSPECT TIMING BELT

NOTICE:
A054953C07
1.292,0.031 1.49,0.177 0.198,0.146 10 false *a 2.719,0.24 2.917,0.417 0.198,0.177 10 false *c 1.875,0.417 2.073,0.583 0.198,0.167 10 false *b
*a INCORRECT
*b Oil
*c Water


·

Do not bend or twist the timing belt, and do not turn the timing belt inside out.

·

Do not allow the timing belt to come into contact with oil, water or steam.



a.

Visually inspect the timing belt.

If defects are present, perform the steps below.


b.

If there is premature parting:

i.

Check for proper installation.


ii.

Check the timing belt cover gasket for damage and proper installation.



c.

If the timing belt teeth are cracked or damaged, check if either camshaft sub-assembly is locked.


d.

If there is noticeable wear or cracks on the timing belt face, check if there are nicks on the side of the No. 1 timing belt idler sub-assembly.


e.

If there is wear or damage on only one side of the timing belt, check the timing belt guide and the alignment of each pulley.


f.

If there is noticeable wear on the timing belt teeth, check the timing belt cover for damage, check that the gasket is installed correctly and check for foreign matter on the pulley teeth.

If necessary, replace the timing belt.


Hide 13505 2.INSPECT NO. 1 TIMING BELT IDLER SUB-ASSEMBLY

a.
A374967C01
2.604,1.719 2.427,1.719 2.427,1.719 2.01,1.354 true 2.646,1.625 2.958,1.823 0.313,0.198 10 false *1
*1 Seal
V100135

Turn


Check that the No. 1 timing belt idler sub-assembly turns smoothly by hand.


b.

Visually check that the seal portion of the No. 1 timing belt idler sub-assembly has no grease on it.

NOTICE:
·

If there is oil, water or other foreign matter on the timing belt or a pulley, repair the leak.

·

Do not allow the timing belt and each pulley to come into contact with oil, water or steam.

·

Before installing the No. 1 idler pulley sub-assembly, be sure to clean each pulley with a cloth or equivalent.

·

When inspecting the No. 1 timing belt idler sub-assembly, do not remove it unless absolutely necessary.




Hide 13505A 3.INSPECT IDLER TENSION SPRING

a.
A057636C02
1.604,1.75 1.844,1.958 0.24,0.208 10 false *a
*a Free Length


Measure the free length of the idler tension spring.

Standard free length:

44.4 to 45.4 mm (1.75 to 1.79 in.)


If the free length is not as specified, replace the idler tension spring.


b.

Measure the tension of the idler tension spring at the installed length.

Standard tension:

53 to 59 N (5.40 to 6.02 kgf, 11.9 to 13.3 lbf) at 52.1 mm (2.05 in.)


If the installed tension is not as specified, replace the idler tension spring.