Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › ECM › from 2016.01
RM3270E _51 Engine / Hybrid System _048729 1GR-FE ENGINE CONTROL _0231381 ECM A

1GR-FE ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ECM removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM Vehicle Identification Number (VIN) registration DTC P0630 is output (Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.

PROCEDURE

Hide 55550 1.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55607 2.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 89661 3.REMOVE ECM

a.

for Pre-Runner:

Disconnect the 6 ECM connectors.


b.

for 4WD:

Disconnect the 2 4WD control ECU connectors, 6 ECM connectors.


c.

Detach the 3 clamps.


d.
A379471C01
0.031,0.031 0.271,0.24 0.24,0.208 10 true *A 0.063,2.469 0.271,2.688 0.208,0.219 10 true *B
*A for LHD
*B for RHD


Remove the bolt, 2 nuts and ECM.


Hide 89533 4.REMOVE 4 WHEEL DRIVE CONTROL ECU (for 4WD)

Hide 89667A 5.REMOVE NO. 1 ECM BRACKET

a.
A379472C01
0.042,0.031 0.281,0.26 0.24,0.229 10 false *A 0.052,2.396 0.271,2.615 0.219,0.219 10 false *B
*A for LHD
*B for RHD


Remove the 2 screws and No. 1 ECM bracket.


Hide 89668 6.REMOVE NO. 2 ECM BRACKET

a.
A379473C01
0.052,0.042 0.281,0.25 0.229,0.208 10 false *A 0.052,2.417 0.281,2.635 0.229,0.219 10 false *B
*A for LHD
*B for RHD


Remove the 2 screws and No. 2 ECM bracket.