Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › from 2016.01
RM3270E _51 Engine / Hybrid System _048729 1GR-FE ENGINE CONTROL _0231387 ENGINE COOLANT TEMPERATURE SENSOR A

1GR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of engine coolant temperature sensor Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 23802B 1.DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY

Hide 89422 2.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.

Disconnect the engine coolant temperature sensor connector.


b.
A356058N01
1.865,1.177 2.333,1.177 true 2.365,1.073 2.719,1.271 0.354,0.198 10 true SST

Using SST, remove the engine coolant temperature sensor.

SST
09817-33191  


c.

Remove the gasket from the engine coolant temperature sensor.