Home › Engine / Hybrid System › 1GR-FE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2016.01
RM3270E _51 Engine / Hybrid System _048729 1GR-FE ENGINE CONTROL _0231390 HEATED OXYGEN SENSOR A

1GR-FE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection After Repair Poor idle, engine start, etc. (Click here)

CAUTION:
A358533

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 37140 1.REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)

Hide 89465 2.REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

a.
A356050

Disconnect the connector.


b.

Detach the 2 clamps.


c.
A356053N01
1.667,1.302 1.667,0.833 true 1.531,1.333 1.875,1.542 0.344,0.208 10 true SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe.

SST
09224-00011  

NOTICE:

Do not damage the heated oxygen sensor.



Hide 89465A 3.REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

a.
A356049

Disconnect the connector.


b.

Detach the 2 clamps.


c.
A356051N01
1.833,0.469 2.01,0.885 2.01,0.885 2.188,0.885 true 2.229,0.781 2.552,0.979 0.323,0.198 10 true SST

Using SST, remove the heated oxygen sensor from the front exhaust pipe.

SST
09224-00011  

NOTICE:

Do not damage the heated oxygen sensor.