Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 1GR-FE) › from 2016.01
RM3270E _55 Steering _041696 POWER ASSIST SYSTEMS _0233635 VANE PUMP(for 1GR-FE) A

POWER ASSIST SYSTEMS  VANE PUMP(for 1GR-FE)  INSTALLATION  


PROCEDURE

Hide 44320 1.INSTALL VANE PUMP ASSEMBLY

a.

Install the vane pump assembly with the 2 bolts.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)


Hide 44410 2.CONNECT PRESSURE FEED TUBE ASSEMBLY

a.

Install a new gasket onto the pressure feed tube assembly.


b.

Install the pressure feed tube assembly with the union bolt.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)

HINT:

Make sure that the stopper of the pressure feed tube touches the front housing.



c.

Connect the power steering oil pressure switch.

NOTICE:

Make sure that no oil adheres to the connector.



Hide 44348A 3.CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE

a.

Connect the No. 1 oil reservoir to pump hose with the clip.


Hide 16361A 4.INSTALL FAN AND GENERATOR V BELT

Hide 53736 5.INSTALL FRONT FENDER APRON SEAL RH

a.

Attach the new 6 clips to install the front fender apron seal RH.


Hide 28800 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 7.ADD POWER STEERING FLUID

Hide 9.CHECK FOR POWER STEERING FLUID LEAKAGE