Home › Engine / Hybrid System › 5L-E ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2016.01
RM3270E _51 Engine / Hybrid System _048946 5L-E ENGINE CONTROL _0235260 CRANKSHAFT POSITION SENSOR G

5L-E ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 11401G 1.INSPECT CRANKSHAFT POSITION SENSOR

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Cold 19 to 32 Ω
1 - 2 Hot 24 to 37 Ω


NOTICE:

In the chart above, the terms "Cold" and "Hot" refer to the temperature of the sensor. "Cold" means approximately -10 to 50°C (14 to 122°F). Hot means approximately 50 to 100°C (122 to 212°F).


If the result is not as specified, replace the crankshaft position sensor.