The necessary procedures(adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ECM removal/installation are shown below.
55550
1.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY
89878
2.REMOVE TURBO MOTOR DRIVER
89661
3.REMOVE ECM
| *A | for LHD |
| *B | for RHD |
Disconnect the 4 ECM connectors and clamp.
Disconnect the 2 4WD control ECU connector.
for Automatic Transmission:
Disconnect the 2 transmission control ECU connector.
Remove the bolt, 2 nuts and ECM, No. 1 and No. 2 ECM brackets.
89533
4.REMOVE 4WD CONTROL ECU
89530C
5.REMOVE TRANSMISSION CONTROL ECU (for Automatic Transmission)
89667A
6.REMOVE NO. 1 ECM BRACKET
| *A | for LHD |
| *B | for RHD |
Remove the 2 screws and No. 1 ECM bracket.
89668A
7.REMOVE NO. 2 ECM BRACKET
| *A | for LHD |
| *B | for RHD |
Remove the 2 screws and No. 2 ECM bracket.