Home › Engine / Hybrid System › 2KD-FTV ENGINE CONTROL › ECM › from 2016.01
RM3270E _51 Engine / Hybrid System _048930 2KD-FTV ENGINE CONTROL _0236331 ECM A

2KD-FTV ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures(adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ECM removal /installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replaced Part or Performed Work Necessary Procedures Effects/Inoperative when not Performed Link
ECM
·

Learning values save

·

Learning values write


Engine starting (Click here)
Code registration (Immobilizer system) Engine start function See the Service Bulletin for the registration method.

PROCEDURE

Hide 55550 1.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 89661 2.REMOVE ECM

a.

Disconnect the 4 ECM connectors and clamp.


b.

for 4WD:

Disconnect the 2 4WD control ECU connector.


c.
A349178C01
0.021,0.031 0.333,0.188 0.313,0.156 10 true *A 0.042,2.302 0.354,2.458 0.313,0.156 10 false *B
*A for LHD
*B for RHD


Remove the bolt, 2 nuts and ECM, No. 1 and No. 2 ECM brackets.


Hide 89533 3.REMOVE 4WD CONTROL ECU (for 4WD)

Hide 89667A 4.REMOVE NO. 1 ECM BRACKET

a.
A349181C01
0.063,0.042 0.375,0.198 0.313,0.156 10 false *A 0.073,2.323 0.385,2.479 0.313,0.156 10 false *B
*A for LHD
*B for RHD


Remove the 2 screws and No. 1 ECM bracket.


Hide 89668A 5.REMOVE NO. 2 ECM BRACKET

a.
A349184C01
0.042,0.031 0.354,0.188 0.313,0.156 10 false *A 0.083,2.448 0.396,2.604 0.313,0.156 10 false *B
*A for LHD
*B for RHD


Remove the 2 screws and No. 2 ECM bracket.