Home › Engine / Hybrid System › 2GD-FTV ENGINE CONTROL › ECD SYSTEM › from 2016.01
RM3270E _51 Engine / Hybrid System _048922 2GD-FTV ENGINE CONTROL _0236344 ECD SYSTEM D

2GD-FTV ENGINE CONTROL  ECD SYSTEM  DTC CHECK / CLEAR  


NOTICE:

When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data stored in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.


HINT:
·

DTCs which are stored in the ECM can be output to the GTS. The GTS can output current and pending DTCs.

·

Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.



CHECK DTC


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Check the DTCs and freeze frame data, and then write them down.

Powertrain > Engine and ECT > Trouble Codes
50001 234



CLEAR DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Clear.


e.

Press the YES button.

Powertrain > Engine and ECT > Clear DTCs
50002 234


CLEAR DTC (Without using GTS)


a.

Perform either one of the following operations.

i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI-B fuse from the No. 1 engine room relay block and junction block assembly for more than 1 minute.