55900
1.INSPECT AIR CONDITIONING CONTROL ASSEMBLY
| *a | Component without harness connected
(Air Conditioning Control Assembly) |
Check the blower switch resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 9 (LO), 6 (HI), 8 (M1) or 10 (M2) - 5 (E) | OFF | 10 kΩ or higher |
| 9 (LO) - 5 (E) | Blower Switch 1 | Below 1 Ω |
| 9 (LO) or 8 (M1) - 5 (E) | Blower Switch 1 - 2 | Below 1 Ω |
| 9 (LO) or 8 (M1) - 5 (E) | Blower Switch 2 | Below 1 Ω |
| 9 (LO), 8 (M1) or 10 (M2) - 5 (E) | Blower Switch 2 - 3 | Below 1 Ω |
| 9 (LO) or 10 (M2) - 5 (E) | Blower Switch 3 | Below 1 Ω |
| 9 (LO), 6 (HI) or 10 (M2) - 5 (E) | Blower Switch 3 - 4 | Below 1 Ω |
| 9 (LO) or 6 (HI) - 5 (E) | Blower Switch 4 | Below 1 Ω |
If the result is not as specified, replace the air conditioning control assembly.
| *a | Component without harness connected
(Air Conditioning Control Assembly) |
Check the cooler volume resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
|---|---|---|
| 4 (SG) - 9 (B/V) | OFF | 10 kΩ or higher |
| 4 (SG) - 9 (B/V) | ON to Max Cool | 3.6 kΩ to 0 Ω |
If the result is not as specified, replace the air conditioning control assembly.
| *a | Component without harness connected
(Air Conditioning Control Assembly) |
Check the recirculation/fresh switch resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 (FRS) - 5 (ERDF) | OFF | Below 1 Ω |
| 2 (LED+) - 5 (ERDF) | OFF | 10 kΩ or higher |
| 2 (LED+) - 5 (ERDF) | ON | Below 1 Ω |
| 1 (FRS) - 5 (ERDF) | ON | 10 kΩ or higher |
If the result is not as specified, replace the air conditioning control assembly.
| *a | Component without harness connected
(Air Conditioning Control Assembly (recirculation/fresh switch)) |
| *b | Indicator |
Check that the recirculation/fresh switch LED illuminates.
Apply battery voltage to the air conditioning control assembly (recirculation/fresh switch) and check that the LED illuminates.
| Measurement Condition | Switch Position | Specified Condition |
|---|---|---|
| Battery positive (+) → 3 (IG)
Battery negative (-) → 5 (ERDF) |
Recirculation/fresh switch: ON | Indicator illuminates |
If the result is not as specified, replace the air conditioning control assembly.