The skid control ECU (brake actuator assembly) receives signals from the 4 wheel drive control ECU via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0073 | Control Module Communication Bus OFF | The condition that the bus OFF state occurs once or more within 0.1 seconds occurs 10 times in succession while the voltage at the IG1 terminal is between 10 and 17.4 V. (Sent signals cannot be received.) | CAN communication system |
| U0114 | Lost Communication with 4WD Control ECU | The CAN signal from the 4 wheel drive control ECU is lost or malfunctioning for 1 second. | ·
CAN communication system ·
Skid control ECU (Brake actuator assembly) ·
4 wheel drive control ECU |
Turn the ignition switch off.
Check if 4 wheel drive control ECU or skid control ECU (brake actuator assembly) is securely connected.
Each connector is securely connected.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Record the output DTCs (for ABS and CAN communication).
for ABS: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR
for CAN communication system for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM
for CAN communication system for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM
If the CAN communication system DTC and the relevant sensor DTCs are output simultaneously, troubleshoot the relevant sensor DTCs (for ABS) after the CAN communication system returns to normal.
| Result | Proceed to |
|---|---|
| DTC (relating to CAN communication system) is output | A |
| DTC (relating to ABS) is output | B |
| DTC is not output | C |
A
for LHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>HOW TO PROCEED WITH TROUBLESHOOTING
for RHD: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING