Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2016.01
RM3270E _54 Brake _041691 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0237426 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  FREEZE FRAME DATA  


FREEZE FRAME DATA


a.

Using the GTS, check the vehicle condition (ECU, sensor) when the brake system operates or a DTC is output.



CHECK FREEZE FRAME DATA WHEN BRAKE SYSTEM OPERATES


a.

Freeze frame data is stored when the brake system operates. The freeze frame data is updated each time the system operates.


b.

Once freeze frame data is stored when the system operates, it is not cleared until the DTC is cleared.


c.

The number of times (maximum: 31) the ignition switch has been turned from off to ON since the last time the system was activated can be stored and displayed.

HINT:
·

When the vehicle is stopped (vehicle speed below 7 km/h (4.3 mph)), turning the ignition switch from off to ON does not cause the value to increase.

·

The value "31" is displayed when the ignition switch was turned on more than 31 times.




d.

Check freeze frame data when the system operates

i.

Turn the ignition switch off.


ii.

Connect the GTS to the DLC3 and turn the ignition switch to ON.


iii.

Enter the following menus: Chassis / ABS/VSC/TRC / Utility.


iv.

Select "ABS History".

Chassis > ABS/VSC/TRC > Utility
Tester Display
ABS History
50005 105 8

v.

Check the freeze frame data when the system operates.




CHECK FREEZE FRAME DATA WHEN DTC WAS STORED


a.

Freeze frame data is stored when a DTC is output.


b.

Once freeze frame data is stored when a DTC is output, it is not updated or cleared until the DTC is cleared.


c.

The number of times (maximum: 31) the ignition switch has been turned from off to ON since a DTC was output can be stored and displayed.

HINT:

The value "31" is displayed when the ignition switch was turned ON more than 31 times.



d.

Check freeze frame data when DTC is output

i.

Turn the ignition switch off.


ii.

Connect the GTS to the DLC3 and turn the ignition switch to ON.


iii.

Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.


iv.

Select a DTC to display the freeze frame data.


v.

Check the freeze frame data for the output DTC.




Chassis > ABS/VSC/TRC
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Elapsed Time after Freeze Trigger Elapsed time after freeze trigger Min.: 0 msec
Max.: 500 msec
- -
Number of IG ON Number of times ignition switch turned to ON after storing freeze frame data 0 to 31 - -
Stop Light SW Stop light switch assembly signal ON or OFF ON: Brake pedal depressed
OFF: Brake pedal not depressed
-
Parking Brake SW Parking brake switch ON or OFF ON: Parking brake applied
OFF: Parking brake released
-
Operated System Operated system status Non, ABS, VSC, TRC, BA, HAB, Fail, PBA, PB, HA-CTRL, TSC or Sys - Non: No operation activated
ABS: ABS activated
Fail: Fail safe mode activated
Sys: System prohibit activated
Forward and Rearward G Deceleration sensor reading Min.: -25.10 m/s2
Max.: 24.90 m/s2
- During acceleration/ deceleration: Changes in proportion with acceleration
FR Wheel Speed Front wheel speed sensor RH reading Min.: 0 km/h (0 mph)
Max.: 326.4 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
FL Wheel Speed Front wheel speed sensor LH reading Min.: 0 km/h (0 mph)
Max.: 326.4 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
RR Wheel Speed Rear wheel speed sensor RH reading Min.: 0 km/h (0 mph)
Max.: 326.4 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
RL Wheel Speed Rear wheel speed sensor LH reading Min.: 0 km/h (0 mph)
Max.: 326.4 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Vehicle Speed Maximum wheel speed sensor value Min.: 0 km/h (0 mph)
Max.: 326.4 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph) When driving at constant speed: No large fluctuations
Vehicle Speed Grade Vehicle acceleration Min.: -25.10 m/s2
Max.: 24.90 m/s2
Vehicle stopped: 0 m/s2 During driving: Changes in proportion with vehicle acceleration/deceleration

CLEAR FREEZE FRAME DATA


NOTICE:

Clearing the DTC also clears the freeze frame data.


a.

Clear the DTCs.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Clear DTCs
50002 105