Home › Power Source / Network › 2GD-FTV BATTERY / CHARGING › GENERATOR › from 2016.01
RM3270E _57 Power Source / Network _048964 2GD-FTV BATTERY / CHARGING _0239209 GENERATOR G

2GD-FTV BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27415 1.INSPECT GENERATOR PULLEY WITH CLUTCH

a.
A226388C02
1.094,0.771 1.219,0.688 false
V100135

Free
V100136

Lock


Hold the center of the generator pulley with clutch, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

If the result is not as specified, replace the generator pulley with clutch.


Hide 27370 2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A113754C10
0.688,0.677 0.865,0.844 0.177,0.167 10 false *a
*a Length


Using a vernier caliper, measure the brush length.

Standard length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum length:

4.5 mm (0.177 in.)


If the length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 3.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A079306

Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.

If necessary, replace the generator rotor assembly.


b.
B012264C19
0.354,1.146 0.479,0.146 0.479,0.146 0.469,1.052 true 0.479,0.156 1.531,0.156 true 1.583,0.063 1.813,0.229 0.229,0.167 10 false *a
*a Slip Ring


Check the generator rotor assembly for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.65 to 2.05 Ω


If the result is not as specified, replace the generator rotor assembly.



c.
B012265C17
1.625,0.458 1.542,0.458 1.542,0.458 1.313,0.76 true 0.448,1.229 0.823,1.594 0.823,1.594 1.052,1.594 false 1.698,0.323 1.854,0.49 0.156,0.167 10 false *a 1.104,1.51 1.281,1.667 0.177,0.156 10 false *b
*a Rotor Core
*b Slip Ring


Check the generator rotor assembly for a short to ground.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor core Always 10 kΩ or higher


If the result is not as specified, replace the generator rotor assembly.



d.

Check each slip ring.

i.

Check that the slip rings are not rough or scored.

If the slip rings are rough or scored, replace the generator rotor assembly.


ii.
B012266

Using a vernier caliper, measure the slip ring diameter.

Standard diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.