This circuit cuts air conditioning operation during vehicle acceleration in order to increase acceleration performance. During acceleration with the vehicle speed at 30 km/h (19 mph) or less and the accelerator pedal opening angle at 45° or more, the A/C magnetic switch is turned off for several seconds.
The air conditioning is also controlled using the engine coolant temperature output from the ECM to the A/C amplifier.
Connect the GTS to the DLC3.
Start the engine and turn the air conditioning switch on.
The A/C magnetic clutch is turned on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the A/C Cut Signal
| Tester Display |
|---|
| Control the A/C Cut Signal |
Check operation of the A/C magnetic clutch cut when air conditioning cut control is operated by the GTS.
A/C magnetic clutch is turned off.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(ECM) |
Start the engine.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G161-9 (ACT) - Body ground | Engine idling | 11 to 14 V |
| G161-9 (ACT) - Body ground | Ignition switch ON,engine stopped | 0 to 3 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A/C amplifier connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-24 (ACT) - G161-9 (ACT) | Always | Below 1 Ω |
| G37-24 (ACT) or G161-9 (ACT) - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG