Home › Engine / Hybrid System › 5L-E FUEL › FUEL INJECTION NOZZLE › from 2016.01
RM3270E _51 Engine / Hybrid System _049532 5L-E FUEL _0237409 FUEL INJECTION NOZZLE A

5L-E FUEL  FUEL INJECTION NOZZLE  REASSEMBLY  


PROCEDURE

Hide 23624 1.INSTALL NOZZLE RETAINING NUT

a.

Install the nozzle assembly, nozzle distance piece and nozzle holder pressure pin to the nozzle retaining nut.


b.

Install the nozzle holder pressure spring and adjusting shim, and then temporarily install the injection nozzle holder to the nozzle retaining nut.


c.
A370273N01
1.104,0.958 1.906,0.958 true 1.104,1.302 1.656,1.302 1.656,1.302 1.656,0.958 true 1.99,0.875 2.448,1.073 0.458,0.198 10 false SST

Using SST, tighten the nozzle retaining nut.

SST
09268-64010  (09268-64020, 09268-64030)

Torque:
46.6 N*m (475 kgf*cm, 34 ft.*lbf)

NOTICE:

Overtightening could cause nozzle deformation and needle adhesion or other defects.



d.

Inspect the nozzle holder and nozzle set.

Click hereEngine / Hybrid System>5L-E FUEL>FUEL INJECTION NOZZLE>INSPECTION