Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › MASS AIR FLOW METER › from 2016.01
RM3270E _51 Engine / Hybrid System _048938 2TR-FE ENGINE CONTROL _0241359 MASS AIR FLOW METER A

2TR-FE ENGINE CONTROL  MASS AIR FLOW METER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the intake mass air flow meter sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of intake mass air flow meter sub-assembly Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 22204 1.REMOVE INTAKE MASS AIR FLOW METER SUB-ASSEMBLY

a.
A344411

Disconnect the intake mass air flow meter connector.


b.

Remove the 2 screws and intake mass air flow meter sub-assembly.