The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the heated oxygen sensor removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
89465
1.REMOVE HEATED OXYGEN SENSOR
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
| *A | for Pre-runner |
| *B | for 4WD |
Disconnect the heated oxygen sensor connector.
for Pre-runner.
Detach the sensor wire from the 4 clamps.
for 4WD.
Detach the sensor wire from the clamp.
| *A | for Pre-runner |
| *B | for 4WD |
Using SST, remove the heated oxygen sensor.