Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH › from 2016.01
RM3270E _51 Engine / Hybrid System _048938 2TR-FE ENGINE CONTROL _0241368 POWER STEERING OIL PRESSURE SWITCH G

2TR-FE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89438D 1.INSPECT POWER STEERING OIL PRESSURE SWITCH

a.

Check the power steering oil pressure switch.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / Power Steering Signal.

Powertrain > Engine > Data List
Tester Display
Power Steering Signal
50003 234 116

v.

Start the engine.


vi.

Read the value displayed on the tester.

OK:
Condition Specified Condition
Power steering operating ON
Power steering not operating OFF


If the result is not as specified, check the wire harness and connector. If the wire harness and connector are normal, replace the power steering oil pressure switch.