Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER SYSTEM › from 2016.01
RM3270E _59 Vehicle Exterior _041717 DOOR / HATCH _0205695 BACK DOOR CLOSER SYSTEM U

DOOR / HATCH  BACK DOOR CLOSER SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Back Door / Active Test.


f.

According to the display on the GTS, read the Data List.

Body Electrical > Back Door > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Door Lock Status Back door condition signal Lock or Unlock Lock: Back door locked
Unlock: Back door unlocked
-
Half Latch SW Half latch switch signal ON or OFF ON: Back door lock motor open-latched
OFF: Back door lock motor full-latched or half-latched
*: Refer to "CONSTRUCTION AND OPERATION"
Closer Position SW Initial switch signal ON or OFF ON: Back door lock center gear in center position (initial switch on)
OFF: Back door lock center gear not in center position (initial switch off)
*: Refer to "CONSTRUCTION AND OPERATION"
Pawl Position Switch Pawl switch signal ON or OFF ON: Back door lock (pawl switch) on
OFF: Back door lock (pawl switch) off
*: Refer to "CONSTRUCTION AND OPERATION"
Courtesy SW Back door courtesy switch signal ON or OFF ON: Back door open
OFF: Back door closed
*: Refer to "CONSTRUCTION AND OPERATION"
IG SW Engine switch signal ON or OFF ON: Engine switch on (IG)
OFF: Engine switch off
"OFF" is also displayed for this item when the engine switch is on (ACC).
#Codes The number of DTCs Min.: 0
Max.: 255
The number of DTCs -

*: Refer to "CONSTRUCTION AND OPERATION"

Click hereVehicle Exterior>DOOR / HATCH>BACK DOOR CLOSER SYSTEM>SYSTEM DESCRIPTION

Body Electrical > Entry&Start > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Tr/B-Door Unlock SW Back door opener switch assembly (open switch) signal ON or OFF ON: Back door opener switch assembly (open switch) on
OFF: Back door opener switch assembly (open switch) off
-


ACTIVE TEST


HINT:

Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Turn the engine switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the engine switch on (IG).


d.

Turn the GTS on.


e.

Enter the following menus: Body Electrical / Back Door / Active Test.


f.

Perform the "Active Test" according to the display on the GTS.

Body Electrical > Back Door > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Latch Release Latch release operation ON or OFF -