Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO ANTENNA CORD › from 2016.01
RM3270E _56 Audio / Visual / Telematics _041699 AUDIO / VIDEO _0203173 RADIO ANTENNA CORD A

AUDIO / VIDEO  RADIO ANTENNA CORD  INSTALLATION  


PROCEDURE

Hide 86101D 1.INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY

a.
E318986

Attach the clamps and guide to install the No. 3 antenna cord sub-assembly.


b.

Install the bolt and connect the connector.

Torque:
8.7 N*m (89 kgf*cm, 77 in.*lbf)


Hide 86101J 2.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY

a.

Align the positioning tape of the No. 2 antenna cord sub-assembly with the protrusions of the roof headlining and wrap the positioning tape around them to install the positioning tape as shown in the illustration.

E320230C01
0.865,1.24 0.76,0.698 true 6.125,0.531 5.677,0.5 true 3.813,1.365 3.969,1.563 0.156,0.198 10 false A 4.094,6.448 4.25,6.646 0.156,0.198 10 false A 0.708,0.531 1.021,0.729 0.313,0.198 10 false *a 5.521,0.427 5.833,0.625 0.313,0.198 10 false *a
*a Positioning Tape - -
V100155

Tape - -



b.

Install the No. 2 antenna cord sub-assembly with the tape aligned to each marking of the roof headlining assembly as shown in the illustration.

HINT:
·

Secure the surplus of the No. 2 antenna cord sub-assembly at the <A> area of the illustration.


·

Secure the front part of the No. 2 antenna cord sub-assembly aligning the edge of the positioning tape and tab section of the roof headlining assembly.


·

Secure the rear part of the No. 2 antenna cord sub-assembly aligning the edge of the positioning tape and tab section of the roof headlining assembly.




Hide 63310 3.INSTALL ROOF HEADLINING ASSEMBLY

Hide 86101 4.INSTALL ANTENNA CORD SUB-ASSEMBLY (for LHD)

a.

Install the antenna cord sub-assembly with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

E333163


b.

Attach the clamps shown in the illustration.


c.

Connect the connector.


Hide 86101 5.INSTALL ANTENNA CORD SUB-ASSEMBLY (for RHD)

a.

w/ Navigation System:

i.

Install the antenna cord sub-assembly with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

E318984


ii.

Attach the clamps shown in the illustration.


iii.

Connect the connector.



b.

w/o Navigation System:

i.

Install the antenna cord sub-assembly with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)

E318983


ii.

Attach the clamps shown in the illustration.


iii.

Connect the connector.



Hide 55302A 6.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).