The theft warning siren has an internal battery. If the vehicle battery cable is disconnected or any of the communication lines are open, the theft warning siren detects this and sounds its siren.
Although the theft warning siren usually sounds by receiving a signal from the body ECU, the theft warning siren can sound by its internal battery in case the vehicle battery cable is disconnected.
The body ECU sends an arming signal to the theft warning siren while transferring to the armed state, and it also sends a disarming signal to the siren while switching to the disarmed state. Also, the body ECU can cause the theft warning siren to sound by sending an alarm signal during the alarm sounding state.
If the theft warning siren assembly is replaced, refer to the Service Bulletin.
Inspect the fuses for circuits related to this system before performing the following procedure.
w/ Door Control Battery:
As the door control battery is installed between the vehicle battery and body ECU, first perform the inspections to confirm that there are no malfunctions in the power source circuit for the body ECU before performing this troubleshooting procedure.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>PRECAUTION
w/ Automatic Light Control System:
If the body ECU has been replaced, it is necessary to initialize the body ECU.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
| *a | Front view of wire harness connector
(to Theft Warning Siren Assembly) |
Disconnect the theft warning siren assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N52-3 (+B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N52-1 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N52 theft warning siren assembly connector.
Disconnect the G34 body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N52-2 (CONT) - G34-11 (SSCL) | Always | Below 1 Ω |
| N52-2 (CONT) - Body ground | Always | 10 kΩ or higher |
| G34-11 (SSCL) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the theft warning siren assembly with a new or normally functioning one.
Refer to the Service Bulletin.
Check the operation of the theft warning siren assembly function.
Theft warning siren assembly function operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU(for RHD)>REMOVAL