Home › Engine / Hybrid System › 2GD-FTV INTAKE / EXHAUST › INTERCOOLER › from 2016.01
RM3270E _51 Engine / Hybrid System _048926 2GD-FTV INTAKE / EXHAUST _0243292 INTERCOOLER G

2GD-FTV INTAKE / EXHAUST  INTERCOOLER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 17940D 1.INSPECT FINS FOR BLOCKAGE

a.

Visually check the intercooler assembly.

i.
A347071C01
1.042,2.969 1.354,3.125 0.313,0.156 10 false *a 2.25,2.948 2.563,3.104 0.313,0.156 10 false *b
*a OK
*b NG


If the intercooler assembly fins are dirty, as shown in the illustration, clean them.



b.

Remove the No. 1 radiator grille retainer (Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REMOVAL).


c.
A112201

Check that the intercooler assembly is not blocked with leaves, dirt or insects.

If the fins are blocked, wash them with water or a steam cleaner.

NOTICE:
·

If the distance between the steam cleaner and core is too close, the fins may be damaged.

·

When cleaning the intercooler assembly, make sure no water enters its interior.

·

Keep the following injection distance.

Standard Injection Distance:
Injection Pressure Specified Condition
2942 to 4903 kPa
(30 to 50 kgf/cm2, 427 to 711 psi)
300 mm (11.811 in.)
4903 to 7845 kPa
(50 to 80 kgf/cm2, 711 to 1138 psi)
500 mm (19.685 in.)


·

If the fins are bent, straighten them with a screwdriver or pliers.

·

Never apply water directly to the electronic components.



HINT:

Above illustration is an example.



d.

Dry the fins with compressed air.


e.

Install the No. 1 radiator grille retainer (Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>INSTALLATION).