Home › Engine / Hybrid System › 1KD-FTV INTAKE / EXHAUST › EXHAUST PIPE › from 2016.01
RM3270E _51 Engine / Hybrid System _048918 1KD-FTV INTAKE / EXHAUST _0243299 EXHAUST PIPE A

1KD-FTV INTAKE / EXHAUST  EXHAUST PIPE  INSTALLATION  


PROCEDURE

Hide 17410 1.INSTALL FRONT EXHAUST PIPE ASSEMBLY

a.
A111834

Using a vernier caliper, measure the free length of the compression spring.

Minimum length:

40 mm (1.57 in.)


If the free length is less than the minimum, replace the compression spring.


b.
A111803C01
2.844,0.677 2.271,0.271 2.271,0.271 2.156,0.271 true 2.865,1.052 2.865,1.448 true 1.917,0.177 2.177,0.406 0.26,0.229 10 false *1 2.792,1.51 3.021,1.74 0.229,0.229 10 false *2
*1 Gasket
*2 Turbine Outlet Elbow


Install a new gasket to the turbine outlet elbow.

NOTICE:
·

Be sure to install the gasket so that it faces the correct direction.

·

Do not reuse the gasket.

·

Do not damage the gasket.

·

When connecting the front exhaust pipe assembly, do not push in the gasket with the front exhaust pipe assembly.




c.
A076194C38
2.031,1.583 1.594,1.885 1.594,1.885 1.479,1.885 true 2.438,0.979 3.042,0.979 true 1.271,1.781 1.49,1.958 0.219,0.177 10 false *1 3.104,0.875 3.323,1.052 0.219,0.177 10 false *a
*1 Gasket
*a Wooden Block


Using a plastic-faced hammer and wooden block, tap on a new gasket until its surface is flush with the turbine outlet elbow.


d.

Install the front exhaust pipe and 2 compression springs with the 2 bolts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)


Hide 17420 2.INSTALL CENTER EXHAUST PIPE ASSEMBLY

a.

Install the center exhaust pipe assembly to the 3 exhaust pipe supports.


b.

Install a new gasket and connect the center exhaust pipe to the front exhaust pipe assembly with the 2 bolts and 2 new nuts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)

NOTICE:

Do not reuse the gasket.



Hide 17430 3.INSTALL TAILPIPE ASSEMBLY

a.

Install the tailpipe assembly to the 4 exhaust pipe supports.


b.

Install a new gasket and connect the tailpipe assembly to the front exhaust pipe assembly with the 2 bolts and 2 new nuts. Alternately tighten the bolts in several passes.

Torque:
43 N*m (438 kgf*cm, 32 ft.*lbf)

NOTICE:

Do not reuse the gasket.



Hide 4.INSPECT FOR EXHAUST GAS LEAK

If gas is leaking, tighten the problem areas to stop the leak. Replace damaged parts as necessary.