19850
1.INSTALL GLOW PLUG ASSEMBLY
Using a 12 mm deep socket wrench, install the 4 glow plug assemblies.
19871
2.INSTALL NO. 1 GLOW PLUG CONNECTOR
Install the No. 1 glow plug resistor insulator.
Install the No. 1 glow plug connector by uniformly tightening the 4 nuts.
Install the 4 screw grommets.
Connect the engine wire and install the No. 2 glow plug resistor insulator and plate washer with the nut.
17130
3.INSTALL INTAKE PIPE
Temporarily install the intake pipe.
| *a | Hose Clamp A |
| *b | Hose Clamp B |
| *c | Bolt |
Install the 2 bolts.
Tighten the 2 hose clamps to secure the intake pipe.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION