Home › Engine / Hybrid System › 5L-E STARTING › GLOW PLUG › from 2016.01
RM3270E _51 Engine / Hybrid System _048957 5L-E STARTING _0243361 GLOW PLUG A

5L-E STARTING  GLOW PLUG  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 17130 3.REMOVE INTAKE PIPE

a.
A118426

Remove the 2 bolts.


b.

Loosen the 2 hose clamps and remove the intake pipe.


Hide 19871 4.REMOVE NO. 1 GLOW PLUG CONNECTOR

a.
A377286C01
1.813,1.688 2.063,1.688 false 1.833,1.938 2.083,1.938 false 1.844,2.167 2.094,2.167 false 1.948,2.427 2.198,2.427 false 1.854,2.99 2.104,2.99 false 2.115,1.604 2.427,1.802 0.313,0.198 10 false *1 2.115,1.854 2.427,2.052 0.313,0.198 10 false *2 2.135,2.083 2.448,2.281 0.313,0.198 10 false *3 2.229,2.354 2.542,2.552 0.313,0.198 10 false *4 2.146,2.906 2.458,3.104 0.313,0.198 10 false *5
*1 Nut
*2 Plate Washer
*3 No. 2 Glow Plug Resistor Insulator
*4 Wire Harness
*5 No. 1 Glow Plug Resistor Insulator


Remove the nut, plate washer and No. 2 glow plug resistor insulator and disconnect the wire harness.


b.

Remove the 4 screw grommets, 4 nuts and No. 1 glow plug connector.


c.

Remove the No. 1 glow plug resistor insulator.


Hide 19850 5.REMOVE GLOW PLUG ASSEMBLY

A118420

a.

Using a 12 mm deep socket wrench, remove the 4 glow plug assemblies.