28100
1.INSTALL STARTER ASSEMBLY
Temporarily install the starter assembly and ground cable with the nut and 2 bolts.
Tighten bolt A and nut B.
Connect the starter wire with the nut.
Connect the starter connector.
Install the starter terminal cap.
28191
2.INSTALL STARTER STAY
Install the starter stay with the nut and 2 bolts.
53882K
3.INSTALL FRONT FENDER SEAL LH
Install the front fender seal LH with 6 new clips.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION