Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER AIRBAG SENSOR ASSEMBLY › from 2016.01
RM3270E _58 Vehicle Interior _041710 SUPPLEMENTAL RESTRAINT SYSTEMS _0199695 CENTER AIRBAG SENSOR ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER AIRBAG SENSOR ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedures listed below are for RHD vehicles.



PROCEDURE

Hide 89170 1.INSTALL AIRBAG SENSOR ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:
·
B394718

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·
B392779

If this procedure is performed without disconnecting the negative (-) terminal of the battery, the airbag may deploy even if an impact is applied only to the airbag sensor assembly. Therefore, make sure that the negative (-) terminal of the battery is disconnected before performing this procedure.




c.
B404137C01
0.896,0.781 1.344,0.448 true 1.771,2.125 2.271,1.865 true 1.375,0.333 1.688,0.49 0.313,0.156 10 false *a 2.323,1.75 2.521,1.927 0.198,0.177 10 true *b
*a Connector Lock
*b Waterproof Sheet
V113147

Lock in this Direction


Check that the waterproof sheet is properly set.


d.

Install the airbag sensor assembly with the 3 bolts.

Torque:
17.5 N*m (178 kgf*cm, 13 ft.*lbf)

NOTICE:
·

If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the airbag sensor assembly with a new one.

·

When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

·

When the ignition switch is first turned to ON after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.




e.

Connect the airbag connector and push the connector lock to lock the airbag connector.

NOTICE:
·

When connecting any airbag connector, take care not to damage the airbag wire harness.

·

Do not allow the water proof sheet to become pinched.




f.

Check that there is no looseness in the installation parts of the airbag sensor assembly.


g.
B409204C01
0,0 0,0 false
V113147

Return in this Direction


for RHD:

Return both sides of the floor carpet to their original positions and install the 2 clips.


Hide 55395C 2.INSTALL INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH (for LHD)

a.

Attach the guide.


b.

Install the inner No. 1 instrument panel bracket cover LH with the 3 clips.


c.
B430748C01
0,0 0,0 false
V113147

Return in this Direction


Return both sides of the floor carpet to their original positions and install the 2 clips.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION