Use these procedures to troubleshoot the LIN communication system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check the CAN communication function to ensure that there are no malfunctions in the communication system.
for LHD:
for RHD:
| Proceed to |
|---|
| No DTCs output |
| DTCs output |
No DTCs output
DTCs output
for LHD:
for RHD:
Using the GTS, check the LIN communication function to ensure that there are no malfunctions in the communication system.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| No DTCs output | A |
| DTC B2785 or B2786 is output | B |
| DTC B14B2 is output | C |
| DTC B14B3 is output | D |
A
B
C
D
Terminals of ECU
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT