The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear crankshaft oil seal removal/installation are shown below.
35000
1.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
32101
2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
Using SST, hold the crankshaft.
Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly, and the front drive plate spacer.
Do not reuse the bolts.
11381A
3.REMOVE REAR CRANKSHAFT OIL SEAL
| *a | Cut Position |
| *b | Protective Tape |
Using a knife, cut off the lip of the rear crankshaft oil seal.
Using a screwdriver, pry out the rear crankshaft oil seal.
Be careful not to damage the crankshaft.
After removing the rear crankshaft oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.
Tape the screwdriver tip before use.