When the ignition switch is turned to ON, battery voltage is applied to terminal IG2 of the TCM.
Inspect the fuses for circuits related to this system before performing the following procedure.
| *a | Rear view of wire harness connector
(to TCM) |
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C116-1 (E1) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Rear view of wire harness connector
(to TCM) |
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G147-6 (IG2) - C116-1 (E1) | Ignition switch ON | 11 to 14 V |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/o Entry and Start System) | B |
| NG (w/ Entry and Start System) | C |
A
B
C
Inspect the ignition switch assembly.
Click hereEngine / Hybrid System>1KD-FTV STARTING>IGNITION SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the IG2 relay.
Click hereEngine / Hybrid System>1KD-FTV ENGINE CONTROL>RELAY>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the IG2 relay from the No. 4 instrument panel relay block assembly.
Disconnect the G147 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| IG2 relay terminal 3 - G147-6 (IG2) | Always | Below 1 Ω |
| IG2 relay terminal 3 or G147-6 (IG2) - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the IG2 relay from the No. 4 instrument panel relay block assembly.
| *A | for RHD | *B | for LHD |
| *1 | No. 4 Instrument Panel Relay Block Assembly | - | - |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| IG2 relay terminal 5 - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G16 certification ECU (smart key ECU assembly) connector.
Remove the IG2 relay from the No. 4 instrument panel relay block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G16-20 (IG1D) - IG2 Relay terminal 1 | Always | Below 1 Ω |
| IG2 Relay terminal 2 - Body ground | Always | Below 1 Ω |
| G16-20 (IG1D) or IG2 Relay terminal 1 - Body ground and other terminals | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG