29341A
1.INSTALL OIL SEAL
Using a SST and a hammer, tap in the oil seal.
29342B
2.INSTALL O-RING
Apply engine oil on a new O-ring and install the O-ring to the vacuum pump case.
29322B
3.INSTALL VACUUM PUMP BEARING
Using a press, press in a new vacuum pump bearing to the vacuum pump shaft.
29336
4.INSTALL VACUUM PUMP SHAFT
Install the vacuum pump shaft and stop ring to the vacuum pump case.
29331
5.INSTALL VACUUM PUMP BLADE
|
Engine oil |
Apply engine oil to the vacuum pump rotor and 5 new vacuum pump blades.
Install the rotor and pump blades with the round end facing outward.
Install the end plate with the 2 screws.
6.INSTALL VACUUM PUMP END COVER
Install the vacuum pump end cover with the 4 screws.
29369
7.INSTALL CHECK VALVE SUB-ASSEMBLY
Using soft jaws, place the vacuum pump in a vise. Then install a new gasket and check valve sub-assembly.
29300F
8.INSTALL VACUUM PUMP VACUUM HOSE UNION
Using SST, hold the check valve sub-assembly, and install 2 new gaskets and the vacuum hose union with the union bolt.
29366
9.INSTALL VACUUM PUMP PULLEY
Install the vacuum pump pulley with the pulley lock nut.