Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
84650
1.INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
|
Install in this Direction |
Attach the claw to install the windshield wiper switch assembly.
Connect the 2 connectors.
45286B
2.INSTALL UPPER STEERING COLUMN COVER
|
Install in this Direction |
Attach the claw to install the upper steering column cover to the steering column assembly.
45287
3.INSTALL LOWER STEERING COLUMN COVER
Make sure to correctly follow the installation procedures. Otherwise, the part may become damaged.
| *A | w/ Entry and Start System |
| *B | w/o Entry and Start System |
|
Install in this Direction |
Attach the claw to install the lower steering column cover to the upper steering column cover.
| *A | w/ Entry and Start System |
| *B | w/o Entry and Start System |
Install the screw.
| *A | w/ Entry and Start System |
| *B | w/o Entry and Start System |
With the steering wheel assembly facing straight ahead, turn the steering wheel 90° to the right and install the screw shown in the illustration.
| *A | w/ Entry and Start System |
| *B | w/o Entry and Start System |
With the steering wheel assembly facing straight ahead, turn the steering wheel 90° to the left and install the screw shown in the illustration.
Operate the tilt and telescopic lever to return the steering position to its original position.
4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION