Home › Engine / Hybrid System › 1KD-FTV STARTING › STARTER(for BOSCH Made) › from 2016.01
RM3270E _51 Engine / Hybrid System _048921 1KD-FTV STARTING _0244697 STARTER(for BOSCH Made) A

1KD-FTV STARTING  STARTER(for BOSCH Made)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53882K 3.REMOVE FRONT FENDER SEAL LH

a.

Remove the 6 clips and front fender seal LH.


Hide 51410 4.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

Hide 51442 5.REMOVE NO. 2 ENGINE UNDER COVER

Hide 6.DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 28100 7.REMOVE STARTER ASSEMBLY

a.

Remove the starter terminal cap.


b.

Disconnect the starter connector.


c.
A372400

Remove the nut and disconnect the starter wire.


d.
A372401

for Automatic Transmission:

Remove the nut, 2 bolts, starter assembly and disconnect the ground cable.


e.

for Manual Transmission:

i.
A372403

Remove the bolt and disconnect the clutch flexible hose bracket.


ii.

Remove the bolt, starter assembly and disconnect the ground cable.