Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(except 2.0 kW Type) › from 2016.01
RM3270E _51 Engine / Hybrid System _048945 2TR-FE STARTING _0244705 STARTER(except 2.0 kW Type) A

2TR-FE STARTING  STARTER(except 2.0 kW Type)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

for Manual Transmission:

i.

Temporarily install the starter assembly with the bolt.


ii.

Temporarily install the clutch flexible bracket with the bolt.


iii.

Tighten the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)



b.

for Automatic Transmission:

i.

Install the starter assembly with the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)



c.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the terminal cap.


e.

Connect the starter connector.


Hide 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY (for Manual Transmission)

Hide 53882F 3.INSTALL FRONT FENDER SEAL LH

a.

Install the front fender seal LH with 6 new clips.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION