Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(for 2.0 kW Type) › from 2016.01
RM3270E _51 Engine / Hybrid System _048945 2TR-FE STARTING _0244707 STARTER(for 2.0 kW Type) A

2TR-FE STARTING  STARTER(for 2.0 kW Type)  DISASSEMBLY  


PROCEDURE

Hide 28120 1.REMOVE STARTER YOKE ASSEMBLY

a.
A343596

Detach the wire harness clamp, remove the nut and disconnect the lead wire from terminal C.


b.

Remove the 2 bolts, and then remove the starter yoke assembly together with the commutator end frame.


c.

Remove the O-ring from the starter yoke assembly.


Hide 28140 2.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A343597

Remove the 2 screws and commutator end frame from the starter yoke assembly.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame.



b.

Remove the O-ring from the starter yoke assembly.


c.

Disconnect the 4 starter brushes from the starter brush holder assembly.

i.
A343598

Using a screwdriver, pull back the spring.


ii.

Disconnect the brush from the starter brush holder assembly.



d.

Remove the starter brush holder assembly from the starter yoke assembly.


Hide 28160 3.REMOVE STARTER ARMATURE ASSEMBLY

NOTICE:

Turn the starter armature assembly and check that it turns freely.


a.

Remove the starter armature assembly from the starter yoke assembly.


Hide 28150 4.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A343599

Remove the 2 screws and starter drive housing assembly.

NOTICE:

Do not drop the idle gear, retainer or clutch roller.



Hide 28011 5.REMOVE STARTER CLUTCH SUB-ASSEMBLY

a.
A343600C01
0.333,0.979 0.333,0.729 false 0.74,0.875 0.74,0.625 false 1.177,0.844 1.177,0.594 false 0.396,1.5 0.563,1.5 0.563,1.5 0.563,1.75 false 1.979,1.948 1.813,1.948 1.813,1.948 1.729,1.698 false 0.667,0.917 0.979,1.115 0.313,0.198 10 false *2 0.26,1.021 0.573,1.219 0.313,0.198 10 false *1 1.115,0.875 1.427,1.073 0.313,0.198 10 false *3 0.24,1.417 0.552,1.615 0.313,0.198 10 false *4 2.021,1.854 2.333,2.052 0.313,0.198 10 false *5
*1 Clutch roller
*2 Retainer
*3 Idle Gear
*4 Return Spring
*5 Starter Clutch Sub-assembly


Remove the idle gear, retainer, clutch roller, starter clutch sub-assembly and return spring from the starter drive housing assembly.


b.
A115020C13
2.677,0.417 2.563,0.417 2.563,0.417 2.135,0.74 false 2.76,0.323 3.042,0.51 0.281,0.188 10 false *a
*a Magnet Hand


Using a magnet hand, remove the steel ball from the clutch shaft hole.