Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(for 2.0 kW Type) › from 2016.01
RM3270E _51 Engine / Hybrid System _048945 2TR-FE STARTING _0244707 STARTER(for 2.0 kW Type) A

2TR-FE STARTING  STARTER(for 2.0 kW Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53882F 3.REMOVE FRONT FENDER SEAL LH

a.

Remove the 6 clips and front fender seal LH.


Hide 28100 4.REMOVE STARTER ASSEMBLY

a.
A302465

Detach the wire harness clamp and remove the bolt to disconnect the wire harness.


b.
A302466

Disconnect the starter connector.


c.

Disconnect the terminal cap.


d.

Remove the nut and disconnect the starter wire.


e.
A316650

Remove the 2 bolts and starter assembly.