Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(for BOSCH Made) › from 2016.01
RM3270E _51 Engine / Hybrid System _048945 2TR-FE STARTING _0244708 STARTER(for BOSCH Made) A

2TR-FE STARTING  STARTER(for BOSCH Made)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Temporarily install the starter assembly with the bolt.


b.

Tighten the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


c.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


d.

Connect the starter connector.


e.

Install the starter terminal cap.


Hide 53882K 2.INSTALL FRONT FENDER SEAL LH

a.

Install the front fender seal LH with new 6 clips.


Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION